Home > Support > ASE2000 V1 -> Knowledge Base

ASE2000 V1 Support

Knowledge Base

The ASE2000 Knowledge Base is an accumulated collection of items that describe various problems and situations that have been encountered with the ASE2000 Test Set and the solutions to those problems. Click on the "Details" that best fits your situation to navigate to the full problem description and resolution.

Some of these issue resolutions have been placed with a PDF files. If you browser has PDF support, the document will open within the browser; otherwise it will download as a PDF document to your PC. The free Adobe PDF reader is available at: http://get.adobe.com/reader/

Knowledge Base
Topic	Details
ADO Exception	ASE2000 has a ADO Exception window pop up at startup
ASE2000 Crashes	Instructions to correct crash at start-up when the ASE2000 had previously been running OK
BCOM-USB	Instructions on removing the BCOM-USB drivers
Capture Files	Instructions for configuration, generation and use of capture files
	Saving Monitoring and Capture Data to Text
CDC	Configuring SCAN 1 and SCAN 3 Exchanges
	Configuring SCAN 1 and SCAN 3 Data PDF version with images
Communication	Baud Rate not on pull-down list
	Framing or Parity Errors with the PCMCIA card
	Carrier settings: switched versus constant
	Pre and Post transmission mark timings
	RS232 DB-9 and DB-25 pinouts
Conitel	Configuring Conitel Scan Exchanges
Display Filtering	Configuring the ASE2000 to show only specific messages, or only to and from a specific RTU
DNP3	Acceptance Test Procedures: special setup
	Creating New DNP3 Exchanges
	File Transfer Capability
	LAN/WAN Configuration procedures
	RTU simulation, class data scan responses
	Source and Destination Address
Events	Explanation of the ASE2000 for event capabilities, which allow the user to declare events on detection of specific messages, of specific digital point changes, of specific analog limit violations, or on communication errors
File Locations	Location information for ASE2000 Version 1 Auxiliary files
Hardware	Procedures to verify PCMCIA card operations
	Procedures to install the PCMCIA drivers under Win2000 or Windows XP
	Procedures to install the Sentinel or Ultra Pro Security dongle under Win2000 or Windows XP
	Procedures to un-install the PCMCIA drivers from Win2000 or Windows XP
	Dual Channel Modem User Guide (Bell202 and V.23)
Harris 5000/6000	How to configure Data Dump and Status Dump exchanges
Help System	Problems accessing on-line help
IEC-60870-5	RTU Simulation procedures for all IEC 60870-5 protocols
	File Transfer messages
	IEC60870-5-104 operational changes as of release 1.46
	IEC 60870-5-104 setup for a master simulation (running as a control station)
	IEC 60870-5-104 network setup procedures
Modbus	Information on Force Multiple Coil and Write Multiple Register Commands
	Modbus TCP configuration procedures
Network Protocols	How to configure for use with a network protocol
	Operating Network protocols in Monitor Mode
	Operating Network protocols in Master Simulation and RTU Simulation Mode modes
PG&E Protocol	PG&E Protocol Configuration Notes
Point List View	Creating and configuring RTU Point information
Wisp+ and Wisp+ Extended	RTU Simulation configuration notes